Audio Technica ATW-3211 EE1

$549.00

ATW-R3210 receiver and ATW-T3201 body-pack transmitter with cH-style screw-down 4-pin connector.

In stock

Description

Operating Frequencies Band DE2: 470.125 to 529.975 MHz (2395 frequencies)
Band EE1: 530.000 to 589.975 MHz (2400 frequencies)
Band EF1: 590.000 to 649.975 MHz (2400 frequencies)
Band FG1: 650.000 to 699.875 MHz (1996 frequencies)
Please note that some frequency bands might not be available in your territory or could come with a limited tuning bandwidth / transmitting power due to local regulations.
Minimum Frequency Step 25 kHz
Modulation Mode FM
Maximum Deviation ATW-T3201: ±38 kHz (THD:10%)
ATW-T3202: ±36 kHz (THD:10%)
Dynamic Range ATW-T3201 Mic input: > 115 dB (A-weighted), typical
ATW-T3201 Inst input: > 112dB (A-weighted), typical
ATW-T3202: > 115 dB (A-weighted), typical
Total Harmonic Distortion <1.0% (at 1 kHz, ±17.5 kHz deviation)
Operating Range 100 m (328′)
Open range environment with no interfering signals.
Operating Temperature Range -5° C to +45° C (23° F to 113° F)
Frequency Response ATW-T3201: 31 Hz to 15,500 Hz
ATW-T3202: 25 Hz to 16,700 Hz
Frequency response depends on attached microphone element
Maximum Simultaneous Use (Recommended) 40 Channels per band*
For assistance with multi-band operation or other frequency coordination issues, please contact your regional Audio-Technica customer service representitive. *Region and band dependent
RECEIVER SPECIFICATIONS
Receiving System True Diversity
Image Rejection 60 dB nominal
RF Sensitivity 20 dBuV at 60 dBA S/N ratio (50 ohms termination)
Antenna Power 12 V DC, 160 mA (combined)
Maximum Output Level XLR, balanced: +14 dBV
6.3 mm (1/4″), unbalanced: +8 dBV
Antenna Input BNC-type, 50 ohms
Power Supply 100-240V AC (50/60 Hz) to 12V DC 1A (center positive) switched mode external power supply
Dimensions 210.0 mm x 191.0 mm x 43.4 mm (W x D x H)
8.27″ x 7.52″ x 1.71″ (W x D x H)
Net Weight 1100 g (38.8 oz), without accessories
Accessories Included Two flexible UHF antennas; AC adapter (country dependent); rack-mount Adapters
BODY-PACK TRANSMITTER SPECIFICATIONS
RF Power Output High: 30 mW, Low: 10 mW (switchable), at 50 ohms
Spurious Emissions Following Federal and National Regulations
Input Connections cH-style screw-down 4-pin connector
Pin 1: GND
Pin 2: INST INPUT
Pin 3: MIC INPUT
Pin 4: DC BIAS +5V
High-pass (low-freq. roll-off) 125Hz, 12dB/octave
Batteries Two 1.5V AA, not included
Battery Life High: 8.0 hours (alkaline), Low: 9.0 hours (alkaline)
High: 9.0 hours (Ni-MH 1900mAh), Low: 9.5 hours (Ni-MH 1900mAh)
Depending on battery type, usage, and environmental conditions.
Dimensions 64 mm x 82 mm x 23 mm (W x D x H)
2.52″ x 3.22″ x 0.91″ (W x D x H)
Net Weight 102 g (3.6 oz), without batteries
HANDHELD TRANSMITTER SPECIFICATIONS
RF Power Output High: 30 mW, Low: 10 mW (switchable), at 50 ohms
Spurious Emissions Following Federal and National Regulations
Microphone Capsule Interchangable industry standard thread
Batteries Two 1.5V AA, not included
Battery Life High: 8.0 hours (alkaline), Low: 9.0 hours (alkaline)
High: 9.0 hours (Ni-MH 1900mAh), Low: 9.5 hours (Ni-MH 1900mAh)
Depending on battery type, usage, and environmental conditions.
Dimensions ATW-T3202 (without capsule): 193 mm (7.60″) long, 37 mm (1.46″) maximum diameter
ATW-T3202/C510: 265 mm (10.43″) long, 54 mm (2.13″) maximum diameter
ATW-T3202/C710: 271 mm (10.67″) long, 50 mm (1.97″) maximum diameter
Net Weight ATW-T3202 (without capsule): 200 g (7.1 oz), without batteries
ATW-T3202/C510: 330 g (11.6 oz), without batteries
ATW-T3202/C710: 314 g (11.1 oz), without batteries

Additional information

Weight .8 kg
Dimensions 20 × 20 × 20 cm

Reviews

There are no reviews yet.

Be the first to review “Audio Technica ATW-3211 EE1”