Description
CONTROLS
TIME – Controls the delay time up to 1000ms. Left is shorter, right is longer.
VOLUME – Controls overall gain of dry and wet sounds. As you turn up the Mix, the dry signal will decrease. You can use the Volume
control to compensate or boost the overall signal.
MIX – Controls volume of the delay repeats only. Left is less, right is more.
RATIO – Controls the tap subdivision: Quarter, dotted-eighth, eighth, and triplet note divisions. The setting of the Ratio control
applies constantly, whether using tap tempo or when manually adjusting the Time knob.
F.BACK – Controls the amount of delay repeats. The Panther Cub V2 has an improved feedback for smooth, infinite repeats or wild
oscillation noises.
EQ – Active EQ tilt control. Noon is “flat”. Turning the knob above noon boosts highs and cuts lows, while turning the knob below
noon boosts lows and cuts highs. Because the Panther Cub V2 is all analog, the overall tone of the repeats is dark even when set at
noon.
JACKS
INPUT – 1/4” jack on the top right receives your instrument’s signal.
OUTPUT – 1/4” jack on the top left sends the signal out of the pedal to an amplifier or pedal chain.
TAP/EXP – 1/4” jack on the right side of the pedal. In Expression Mode, connect any TRS expression pedal to control Time, Ratio, or
Mod Speed. To program, follow the directions below. In Tap Mode, you can set the speed using an external tap tempo pedal. Choose
which one you want by the TAP/EXP switch on the inside of the pedal.
SWITCHES
BYPASS – Left footswitch turns the pedal on and off.
TAP TEMPO – Right footswitch taps in the speed of the delay.
MOD ON/OFF – Turns the modulation on or off for the repeats only.
MOD SPEED +/- – Selects between faster or slower modulation speeds.
INTERNAL TAP/EXP SWITCH – Switch on the inside of the pedal let’s you choose between tap or expression mode for the TAP/
EXP jack.
PROGRAM MODE
With the Panther Cub V2 you have the ability to control Time, Ratio, or Mod Speed with a TRS expression pedal. To select which
parameter to control, hold down the Tap Tempo switch until the tempo LED stops blinking. Once it stops blinking, you are in program
mode. Select which parameter to control by either turning the Time or Ratio knob or by switching the Mod Speed switch one time.
Once you have done this, tap the Tap Tempo switch again and you will exit program mode. You will now be able to control the
parameter you selected with your expression pedal.
POWER – Uses 9V DC negative center power. Do not use more than 9V DC. Your warranty will be voided
Reviews
There are no reviews yet.